Skip to main content
Skip table of contents

Linking an Oracle pluggable database

This topic describes how to link an Oracle 12c pluggable database to the Delphix Engine to create a dSource.

Prerequisites

  • Make sure the Delphix Engine has already discovered the multitenant container database and its pluggable databases. If the container database does not exist in the environment, follow the steps in Adding a Database to an Oracle Environment. If the pluggable database you want to link does not exist in the environment, refer to step 4 in the procedure below.

  • You should have Block Change Tracking (BCT) enabled for the container database, as described in Requirements for Oracle Hosts and Databases.

  • The container database should be in ARCHIVELOG mode and the NOLOGGING option should be disabled, as described in Requirements for Oracle Hosts and Databases.

Procedure

  1. Log into the Delphix management application.

  2. Select Manage > Datasets.

  3. Click the Plus icon and select Add dSource.

  4. In the Add dSource wizard, select the source pluggable database. If the container database is shown but the pluggable database is not, select the container database, enter its database credentials, and click Verify credentials. The Delphix Engine will discover and list all pluggable databases in the container database. Select the pluggable database from the list. Alternatively, you can use the Environment management screen to discover pluggable databases in any of the discovered container databases.

  5. Enter your login credentials for the source database and click Verify credentials.

  6. Click Next.

  7. Select a Database group for the dSource.

  8. Click Next.

  9. Select an Initial load option. By default, the initial load takes place upon completion of the linking process. Alternatively, you can set the initial load to take place according to the SnapSync policy. For example, you can set the initial load to take place when the source database is not in use, or after a set of operations have taken place.

  10. Select a SnapSync policy. See Data Management Settings for Oracle Data Sources for more information.

  11. Click Next.

  12. Review the dSource configuration and Data management information.

  13. Click Submit. The Delphix Engine will initiate two jobs, DB_Link and DB_Sync, to create the dSource. You can monitor these jobs by clicking Active Jobs in the top menu bar, or by selecting System > Event Viewer. When the jobs have completed successfully, the database icon will change to a dSource icon on the Environments > Datasets screen, and the dSource will be added to the list of Datasets under its assigned group. Link/Sync of the Multitenant Container Database The DB_Link job will also link the pluggable database's multitenant container database if it has not been linked yet.

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.